How do you know when to use 365 nm or 395 nm ultraviolet wavelengths? This Tech Note written by Matt
FAQs
Here you’ll find some frequently asked questions that may help you with our products.
How Do I Wire for Specialty Lights?
Although most of our lights use a standard 5 pin M12 cable, there are a few outliers that use a
How Do I Wire Lights for Multi-Driveâ„¢?
Below is a diagram that can help you to wire your lights that have Multi-Driveâ„¢. If you need further help,
How Do I Wire Lights for Constant Operation?
Below is a diagram to help you wire your lights for constant operation. If you need further help, feel free
How Do I Wire a 5 Pin M12 Cable?
See our 5 Pin M12 wiring data sheet for detailed instructions on wiring lights with these types of cables. If
What Connection Is Needed for the NPN or PNP Signal Lines?
NPN stands for negative, positive, negative. It is also known as sinking. PNP stands for positive, negative, positive. It is
What Signal or Connection Can Be Used to Control the Analog Intensity of Our Standard, Multi-Driveâ„¢ and OverDriveâ„¢ Strobe Lights?
The majority of Smart Vision Lights products are equipped with analog intensity and can be wired using the 1-10VDC analog
What Is the Difference Between Continuous, Multi-Driveâ„¢ and OverDriveâ„¢ Lights?
Continuous Operation: Continuous operation refers to any Smart Vision Lights’ light that is rated to be continuously on. These lights
What Is the Difference Between Using On/Off Input and Strobing a Light?
On/off Input: This refers to using a Smart Vision Lights’ continuous operation light in a setup where the light is